New to Framing? get started here
How to Stretch a Canvas using Stretcher Bars
Learn how to stretch inkjet canvas using stretcher bars. Using high quality slotted Stretcher Bars or Stretcher Profiles in Lengths can make canvas production more efficient and helps you to deliver a consistently high quality finished canvas. Carefully selected timber and sophisticated processes used by our manufacturer means that our bars slot neatly together and our profiles in lengths are straight and knot-free - giving minimal wastage.
-
1) Assemble four stretcher bar pieces by pushing the corners together and knocking them into place with a soft headed hammer.
-
2) Make sure the frame is square. Measure from corner to corner, the measurements of both diagonals should match. If not, tap the corners slightly, measuring as you go. Continue to tap the corners until the measurements match.
-
3) If using a canvas alignment gauge to help you position and mark out a printed canvas ready for trimming and stretching gallery style onto stretcher bars.
Cut from notch 1, then notch 2, then cut along the diagonal.
-
4) Repeat step 3 for each corner then remove the excess canvas. Flip the canvas onto its front, locate the small cuts made in step 3, and draw lines between the cuts. This will help to align the stretcher frame.
-
5) Place the stretcher bar frame down on the back of the canvas, aligning it with the lines drawn in step 4. Fold one end of the canvas over the stretcher bar and use a staple gun to fire staples to fit the canvas in place. Start with the middle area and fire staples at a 45° angle. Don't fire staples too close the stretcher frame corner, keep them central.
-
6) On the opposite side, grip the canvas in the middle with stretcher pliers. Pull down to tension the canvas, then staple as before. Repeat this process for all edges.
-
7) Grip and staple the canvas between the middle and sides. Space the staples approximately 50mm apart, leaving 70mm space at each end. Continue this process for all sides.
-
8) Stretch the canvas over the corners by pulling down on one edge while holding the other against the frame. Fold the canvas in half and pull it back around the back of the stretcher frame.
-
9) Keep the corner fold tight and staple the canvas to the frame. Take care not to staple over the join of the stretcher bars. By stapling the join it removes the option of retensioning of the canvas. Repeat steps 8 & 9 for all 4 corners.
-
10) Finish the back of the canvas by trimming away the excess and applying brown self-adhesive tape to the back. This makes the back neat and tidy, covering staples and folded corners.
Apply CWH Hangers to hang the canvas.
-
11) Add Foam Bumpers to the bottom corners of the stretched canvas. Push wedges into the corners of the stretcher bar frame, these are used to retension the canvas in future.